Users Guide

IPv4 and IPv6 Multicast 1673
L3 Multicast Configuration Examples
This section contains the following configuration examples:
• Configuring Multicast VLAN Routing With IGMP and PIM-SM
• Configuring DVMRP
Configuring Multicast VLAN Routing With IGMP and PIM-SM
This example describes how to configure a Dell EMC Networking N-Series
switch with two VLAN routing interfaces that route IP multicast traffic
between the VLANs. PIM and IGMP are enabled on the switch and interfaces
to manage the multicast routing. VLAN 10 is statically configured as the RP
for the multicast group.
The configuration in this example takes place on L3 switch A shown in
Figure 46-54. The red arrows indicate the path that multicast traffic takes. L3
Switch A is configured as the RP for the PIM domain, so it is in charge of
sending the multicast stream to L3 Switch B and L3 Switch C, and these
switches forward the multicast data to the hosts that have requested to
receive the data.
NOTE: PIM does not require OSPF specifically; static routing or RIP could also
be configured for unicast routing.