Users Guide

Layer 3 Routing Commands 1547
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode.
User Guidelines
Configuring a static link local address replaces any previously configured
address, including the automatically generated address.
Command History
Command updated in version 6.6 firmware.
Example
The following example configures an IPv6 address and enables IPv6
processing.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 address 2020:1::1/64
ipv6 enable
Use the ipv6 enable command in to globally enable IPv6 routing. Use the no
form of the command to disable IPv6 routing.
Syntax
ipv6 enable
no ipv6 enable
Default Configuration
IPv6 routing is disabled by default.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.