Users Guide

Layer 3 Routing Commands 1781
exit-overflow-interval
Use the exit-overflow-interval command in Router OSPFv3 Configuration
mode to configure the exit overflow interval for OSPF. It describes the
number of seconds after entering Overflow state that a router will wait before
attempting to leave the Overflow State. This allows the router to originate
non-default AS-external-LSAs again. When set to 0, the router will not leave
Overflow State until restarted.
Syntax
exit-overflow-interval seconds
no exit-overflow-interval
• seconds — Exit overflow interval for OSPF (Range: 0-2147483647)
Default Configuration
0 is the default value for seconds.
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the exit overflow interval for OSPF at 100
seconds.
console(config)#ipv6 router ospf
console(config-rtr)#exit-overflow-interval 100
external-lsdb-limit
Use the external-lsdb-limit command in Router OSPFv3 Configuration
mode to configure the external LSDB limit for OSPF. If the value is -1, then
there is no limit. When the number of non-default AS-external-LSAs in a
router's link-state database reaches the external LSDB limit, the router enters
overflow state. The router never holds more than the external LSDB limit