Users Guide

Switch Management Commands 2012
Command Mode
Privileged Exec and User Exec modes, Global Configuration mode and all
Configuration submodes
User Guidelines
This command has no user guidelines.
Example
The following example displays the configured DHCP pool based on the
entered IPv6 address.
console#show ipv6 dhcp binding 2020:1::
show ipv6 dhcp interface
Use the show ipv6 dhcp interface command in User Exec or Privileged Exec
mode to display configuration and status information about an IPv6 DHCP
specified interface or all interfaces. If an interface is specified, the optional
statistics parameter is available to view statistics for the specified interface.
Syntax
show ipv6 dhcp interface [interface-id] [statistics]
• interface-id—A tunnel or VLAN interface identifier. See Interface Naming
Conventions for interface representation.
• statistics — Enables statistics display if interface is specified.
Default Configuration
This command has no default configuration.
Command Mode
User Exec, Privileged Exec modes, Global Configuration mode and all
Configuration submodes
User Guidelines
This command shows the DHCP status. Statistics are shown depending on
the interface mode (relay, server, or client).