Users Guide

Switch Management Commands 2138
Only IPv4 addresses are supported with the vrf parameter.
This command is only available on the N3000-ON/N3100-ON/N3200-ON
switches.
Debug output should be enabled with caution. Switch behavior may be
adversely affected by the additional processing load incurred from enabling
debug.
Example
console#debug ospf packet
debug ospfv3 packet
Use the debug ospfv3 packet command to enable tracing of OSPFv3 packets
received and transmitted by the switch. Use the no form of this command to
disable tracing of OSPFv3 packets.
Syntax
debug ospfv3 packet
no debug ospfv3 packet
Default Configuration
Display of OSPFv3 traces is disabled by default.
Command Mode
Privileged Exec mode.
User Guidelines
Debug output should be used with caution. Switch behavior may be adversely
affected by the additional processing load incurred from enabling debug
output. Use of debug level logging when performing operations such as switch
failover is not recommended.
Debug messages are sent to the system log at the DEBUG severity level. To
print them on the console, enable console logging at the DEBUG level
(logging console debug).