Users Guide

Switch Management Commands 2208
contact-company
Use the contact-company command to configure the contact information to
be sent to the SupportAssist server. Use the no form of the command to
remove the contact information.
Syntax
contact-company name company street-address streetaddress address city
city country country postcode postcode
• company — The company for the technical contact person. Maximum
of 256 printable characters.
• streetaddress — The street address for the technical contact person.
Maximum of 99 printable characters.
• city — The city for the technical contact person. Maximum of 99
printable characters.
• country — The country for the technical contact person in Alpha-3
format-3 capital-case characters.
• postcode — The postal code for the technical contact person. Maximum
of 10 printable characters.
Enclose a parameter in quotes if an embedded blank is desired in the
parameter.
Default Configuration
No contact company information is populated by default.
Command Mode
Support Assist Configuration
User Guidelines
This information is transmitted to Dell if the SupportAssist service is
enabled.
This command can be executed multiple times. It overwrites the previous
information each time. The collected information is stored in the running-
config. The administrator must write the configuration in order to persist it
across reboots.