Users Guide

Layer 2 Switching Commands 294
User Guidelines
This command is not supported on the N1500 Series switches.
Example
console#show service-acl interface te1/0/1
console(config-if-Te1/0/1)#show service-acl interface te1/0/1
Service-acl Interface Te1/0/1
Protocol Mode
--------------- ----------
CDP Disabled
VTP Disabled
DTP Disabled
UDLD Enabled
PAGP Disabled
SSTP Disabled
ALL Disabled
show access-lists interface
Use the show access-lists interface command to display interface ACLs.
Syntax
show access-lists interface {interface-id {in | out}} | control-plane
• interface-id — The interface identifier (Ethernet, port-channel, or
VLAN).
• in— Show the ingress ACLs.
• out— Show the egress ACLs.
• control-plane— Show the control plane ACLs.
Default Configuration
No ACLs are configured by default.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes