Users Guide

Layer 2 Switching Commands 584
ipv6 mld snooping querier timer expiry
Use the ipv6 mld snooping querier timer expiry command to set the MLD
Querier timer expiration period. Use the no form of this command to reset
the timer expiration period to the default.
Syntax
ipv6 mld snooping querier timer expiry timer
ipv6 mld snooping querier timer expiry
• timer — The time that the switch remains in Non-Querier mode after it
has discovered that there is a multicast querier in the network. (Range: 60–
300 seconds)
Default Configuration
The default timer expiration period is 60 seconds.
Command Mode
Global Configuration mode
User Guidelines
The timer expiry is the time period that the switch remains in non-querier
mode once it has discovered that there is another multicast querier in the
network.
Example
console(config)#ipv6 mld snooping querier timer expiry 222
show ipv6 mld snooping querier
Use the show ipv6 mld snooping querier command to display MLD
Snooping Querier information. Configured information is displayed whether
or not MLD Snooping Querier is enabled.
Syntax
show ipv6 mld snooping querier [detail | vlan vlan-id]
• vlan-id — A VLAN identifier (Range: 1 - 4093)