Users Guide

RIP 1325
Configuring RIP Features (CLI)
This section provides information about the commands used for configuring
RIP settings on the switch. For more information about the commands, refer
to the Dell EMC Networking N2000, N2100-ON, N2200-ON, N3100-ON
Series Switches CLI Reference Guide at www.dell.com/support.
Configuring Global RIP Settings
Use the following commands to configure various global RIP settings for the
switch.
NOTE: RIP is enabled by default. The Global RIP Settings are optional.
Command Purpose
configure Enter global configuration mode.
router rip Enter RIP configuration mode.
split-horizon {none |
simple | poison}
Set the RIP split horizon mode.
• none — RIP does not use split horizon to avoid routing
loops.
• simple — RIP uses split horizon to avoid routing loops.
• poison — RIP uses split horizon with poison reverse
(increases routing packet update size).
auto-summary Enable the RIP auto-summarization mode.
no hostroutesaccept Prevent the switch from accepting host routes.
default-information
originate
Control the advertisement of default routes.
default-metric metric-
value
Set a default for the metric of distributed routes.
The metric-value variable is the metric (or preference) value
of the default route. (Range: 1–15)
enable Reset the default administrative mode of RIP in the router
(active)
CTRL + Z Exit to Privileged Exec mode.
show ip rip View various RIP settings for the switch.