Users Guide

Setting Basic Network Information 195
Configuring Basic Network Information (Web)
This section provides information about the OpenManage Switch
Administrator pages for configuring and monitoring basic network
information on the Dell EMC Networking N-Series switches. For details
about the fields on a page, click at the top of the Dell EMC
OpenManage Switch Administrator web page.
Out-of-Band Interface
Use the Out of Band Interface page to assign the out-of-band interface IP
address and subnet mask or to enable/disable the DHCP client for address
information assignment. DHCP is enabled by default on the OOB interface.
The OOB interface must be configured on a subnet separate from the front-
panel port routing interfaces. The system default gateway must not share an
address range/subnet with the OOB interface.
The out-of-band interface may also be assigned an IPv6 address, either
statically or via DHCP. In addition, the out-of-band port may be assigned an
IPv6 address via the IPv6 auto-configuration process.
To display the Out of Band Interface page, click System  IP Addressing 
Out of Band Interface in the navigation panel.
NOTE: Dell EMC Networking, N1100-ON, N1500, N2000, and N2100-ON Series
switches do not have an out-of-band interface.