Users Guide

418 Monitoring and Logging System Information
Monitoring System Information and Configuring
Logging (CLI)
This section provides information about the commands used for configuring
features for monitoring on the Dell EMC Networking N1100-ON, N1500,
N2000, N2100-ON, N3000E-ON, and N3100-ON Series switches. For more
information about these commands, see the Dell EMC Networking N1100-
ON, N1500, N2000, N2100-ON, N2200-ON, and N3100-ON Series Switches
CLI Reference Guide at www.dell.com/support.
Viewing System Information and Enabling the Locator LED
Use the following commands to view system health and resource information
and to enable the switch locator LED.
Running Cable Diagnostics
Use the following commands to run the cable diagnostic tests.
Command Purpose
show system Display various system information.
show system power Display the power supply status.
show system
temperature
Display the system temperature and fan status.
show memory cpu Display the total and available RAM space on the switch.
show process cpu Display the CPU utilization for each process currently
running on the switch.
locate [switch unit]
[time time]
Enable the switch locator LED located on the switch.
Optionally, the unit to identify within a switch stack and
the length of time that the LED blinks can be specified.
NOTE: Cable diagnostics may give misleading results if green mode is enabled
on the port. Disable green mode prior to running any cable diagnostics.