Users Guide

466 Managing General System Settings
power inline detection [unit
unit-id] {dot3at |
dot3at+legacy-
only|dot3bt|dot3bt+legacy}
Set the power-management mode for the switch or
the specified stack unit.
• dot3at—IEEE 802.3at detection scheme is used.
• dot3at+legacy-only—IEEE 802.3at 4point
detection scheme is used and when it fails to
detect a connected PD, legacy capacitive detection
is used.
• dot3bt—IEEE 802.3bt detection scheme is used.
N2200PX-ON switch only.
• dot3bt+legacy—A modified IEEE 802.3bt
detection scheme is used. N2200PX-ON switch
only.
interface interface Enter interface configuration mode for the specified
port. The interface variable includes the interface
type and number, for example gigabitethernet 1/0/3.
power inline {auto | never} Set the PoE device discovery admin mode.
• auto — Enables the device discovery protocol and,
if found, supplies power to the device.
• never — Disables the device discovery protocol
and stops supplying power to the device.
power inline priority {critical |
high | low}
Configures the port priority level for the delivery of
power to an attached device.
power inline four-pair forced Enable power feed on all pairs.
power inline powered-device
type
Provide a description to represent the type of device
connected to the port.
power inline reset (Optional) Reset the port. You might use this
command if the port is stuck in an Error state.
CTRL + Z Exit to Privileged Exec mode.
show power inline Display PoE information for the switch.
show power inline interface Display PoE information for the specified interface.
Command Purpose