Users Guide

Port and System Security 665
the difference is that all sticky addresses for an interface are removed from the
running-config when the interface is taken out of sticky mode. Static
addresses must be removed from the running-config individually.
Sticky MAC addresses appear in the running-config in the following form:
switchport port-security mac-address sticky
0011.2233.4455 vlan 33
Statically locked MAC addresses appear in the running-config in the
following form:
switchport port-security mac-address
0011.2233.4455 vlan 33
Default Port Security Values
Table 18-1 lists the default values for the Port Security feature.
Configuring Port Security Configuration (Web)
This section provides information about the OpenManage Switch
Administrator pages for configuring and monitoring the IEEE 802.1X
features and Port Security on Dell EMC Networking N1100-ON, N1500,
N2000, N2100-ON, N2200-ON, and N3100-ON Series switches. For details
about the fields on a page, click at the top of the Dell EMC
OpenManage Switch Administrator web page.
Port Security
Use the Port Security page to enable MAC locking on a per-port basis. When
a port is locked, a limit can be specified for the number of source MAC
addresses that are allowed to transmit traffic on the port.
Table 18-1. Default Port Security Values
Feature Description
Port security Unlocked
Port security traps Enabled
Maximum learned MAC addresses 600 (when locked)
Maximum static MAC addresses 100
Monitor mode Disabled