Users Guide

Table Of Contents

VLANs 839

Figure 21-33. Trunk Port Configuration

Repeat steps b–d to add additional MAC address-to-VLAN

information for the Sales department.

To save the configuration so that it persists across a system reset, use the

following steps:

Go to the

System



File Management Copy Files page

Select Copy Configuration and ensure that Running Config is the

source and Startup Config is the destination.

Click Apply.

Configure the VLANs and Ports on Switch 2

Use the following steps to configure the VLANs and ports on Switch 2. Many

of the procedures in this section are the same as procedures used to configure

Switch 1. For more information about specific procedures, see the details and

figures in the previous section.

To configure Switch 2:

Create the Engineering, Marketing, Sales, and Payroll VLANs.

Although the Payroll hosts do not connect to this switch, traffic from the

Payroll department must use Switch 2 to reach the rest of the network and

Internet through the uplink port. For that reason, Switch 2 must be aware

of VLAN 400 so that traffic is not rejected by the trunk port.

Configure LAG 1 as a general port so that it can be a member of multiple

VLANs.

From the

Switching



VLAN



LAG Settings page, make sure Po1

is selected.

From the Port VLAN Mode field, select General.