Administrator Guide

Data Center Technology Commands 1198
When the switch tables parameter is given, the following information is
displayed:
Disable Reason If the OpenFlow feature is operationally disabled then this
status shows the reason for the feature to be disabled.
IP Address IPv4 Address assigned to the feature. If the IP address is
not assigned then the status is ‘None’.
IP Mode IP mode assigned by the ‘openflow ip-mode’ command.
The IP Mode can be “Auto”, “Static” or “ServicePort IP”
Static IP Address Static IP address assigned by the ‘openflow static-ip-
address’ command.
Network MTU Maximum network packet size excluding the VLAN Tag.
OpenFlow Variant OpenFlow Protocol Variant. The OpenFlow protocol can
be “OpenFlow 1.0” or “OpenFlow 1.3”.
Default Table The Hardware Table used as the target for flows installed
by an OpenFlow 1.0 controller which is not enhanced to
handle multiple hardware tables.
Passive Mode The OpenFlow passive mode set by the ‘passive’ command.
Parameter Description
Flow Table. OpenFlow Table Identifier (0 – 255).
Flow Table Name. The name of this table.
Flow Table Description. A detailed description for this table.
Maximum Size. Platform-defined maximum size for this flow table.
Number of Entries. Total number of entries in this table. The count includes
delete-pending entries.
Hardware Entries. Number of entries currently inserted into the hardware.
Software-Only Entries. Number of entries that are not installed in the hardware
for any reason. This includes entries pending for insertion,
entries that cannot be inserted due to missing interfaces
and entries that cannot be inserted due to table-full
condition.
Parameter Description