Administrator Guide

Dell EMC Networking CLI 159
Priority Flow Control
Layer 3 Routing Commands
ARP (IPv4)
openflow Enables OpenFlow on the switch (if disabled)
and enters into OpenFlow configuration mode.
GC
passive Sets the switch to wait for the controller to
initiate the connection.
OFC
protocol-version Selects the version of the protocol in which to
operate.
OFC
show openflow Displays OpenFlow configuration and status. PE,
GC
a. For the meaning of each Mode abbreviation, see Mode Types .
Command Description Mode
a
a. For the meaning of each Mode abbreviation, see Mode Types .
Data Center Bridging
Capability Exchange
Commands
Enables Priority-Flow-Control (PFC) on an
interface.
DCB
priority-flow-control priority Enables the priority group for lossless (no-drop)
or lossy (drop) behavior on the selected
interface.
DCB
clear priority-flow-control
statistics
Clears all or interface Priority-Flow-Control
statistics.
PE
show interfaces priority-
flow-control
Displays the global or interface priority flow
control status and statistics.
PE
Command Description Mode
a
arp Creates an Address Resolution Protocol (ARP)
entry.
GC
Command Description Mode
a