Administrator Guide

Switch Management Commands 2087
Command Mode
Privileged Exec mode.
User Guidelines
The VRF identified in the parameter must have been previously created or an
error is returned.
Only IPv4 addresses are supported with the vrf parameter.
This command is only available on the N3000/N3100/N4000 switches.
Debug output should be enabled with caution. Switch behavior may be
adversely affected by the additional processing load incurred from enabling
debug.
Example
console#debug ospf packet
debug ospfv3
Use the debug ospfv3 command to enable tracing of OSPFv3 packets
received and transmitted by the switch. Use the “no” form of this command
to disable tracing of OSPFv3 packets.
Syntax
debug ospfv3 packet
no debug ospfv3 packet
Default Configuration
Display of OSPFv3 traces is disabled by default.
Command Mode
Privileged Exec mode.
User Guidelines
Debug output should be enabled with caution. Switch behavior may be
adversely affected by the additional processing load incurred from enabling
debug.