Users Guide

Data Center Technology Commands 1192
Example
The following example demonstrates how to limit the maximum bandwidth
percentage for TCG 1 and 2 to 25% each.
console(config)# traffic-class-group max-bandwidth 50 25 25
traffic-class-group min-bandwidth
Use this command in Global Config or Interface Configuration mode to
specify the minimum transmission bandwidth guaranteed for each TCG
before processing frames from other TCGs on an interface.
Use the no form of the command to return the bandwidth reservations to the
default values.
Syntax
traffic-class-group min-bandwidth bw-0 bw-1 … bw-n
no traffic-class-group min-bandwidth
• bw-0..7—The maximum percentage bandwidth to be transmitted by the
TCG. Range 0 to 100.
Default Configuration
The default minimum bandwidth for all TCGs is 0% (no minimum
guarantee).
Command Mode
Global Configuration mode, Interface Configuration mode
User Guidelines
NOTE: This command is only available on N40xx series switches.
This command specified in Interface Configuration mode only affects a
single interface, whereas the Global Configuration mode setting is applied to
all interfaces. The Interface Configuration mode command is only available
on the N4000 series switches.
Each bw-x value is a percentage that ranges from 0 to 100 in increments of 1.
All n bandwidth values must be specified with this command, and their
combined sum must not exceed 100%. The default minimum bandwidth