Users Guide

Switch Management Commands 2199
Example
This example set the logging message format to RFC5424. DTLS is used for
X509 configured SYSLOG servers if a certificate is available.
console(config)#logging protocol 1
This example sets the logging message format to RFC3164
console(config)#no logging protocol
The following example shows the logging format when logging protocol is set
to 0.
console(config)#logging protocol 0
console(config)#
<190> Oct 18 07:09:15 0.0.0.0-1 RADIUS[radius_task]: radius_api.c(10450) 58
%% INFO RADIUS: Sending RADIUS server state change event to interested users:
1
<189> Oct 18 07:09:15 0.0.0.0-1 TRAPMGR[trapTask]: traputil.c(721) 26 %% NOTE
Unit 1 is the new stack master, Old stack master unit is 0
The following example shows the logging format when logging protocol is set
to 1.
console(config)#logging protocol 1
console(config)#
<190>1 2017-10-18T07:09:23.446Z dhcp-10-130-182-178 UNITMGR cmgrInsertTask
unitmgr.c(8063) 232 [stk@674 unit:1][sev@674 INFO] %% No Potential unit to
configure as Standby when unit 1 joined
<189>1 2017-10-18T07:09:23.445Z dhcp-10-130-182-178 USB_FD emWeb
usbFlashDrive_core.c(903) 231 [stk@674 unit:1][sev@674 NOTE] %% There is
startup-config on flash.
<190>1 2017-10-18T07:09:23.432Z dhcp-10-130-182-178 AUTO_INST emWeb
auto_install_control.c(1358) 230 [stk@674 unit:1][sev@674 INFO] %%
AutoInstall is stopped.
The following example shows the logging format when logging protocol is set
to 1 with timezone configured on the switch.
console(config)#clock timezone +5 minutes 30 zone IST
console(config)#show clock
02:17:44 IST(UTC+5:30) Dec 21 2014
Time source is Local
console(config)#