Users Guide

Switch Management Commands 2298
update bootcode
Use the update bootcode command to update the bootcode on one or more
switches. For each switch, the bootcode is extracted from the active image
and programmed to flash.
Syntax
update bootcode [unit ]
• unit —Unit number.
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode
User Guidelines
It is not required to update the boot code unless directed to do so in the
release notes. Dell EMC Networking switches utilize a universal boot loader
and do not contain version specific dependencies in the boot loader. If unit is
not specified, all units in the stack are updated. This command does not
reboot the stack members after the update completes. Do not reload or power
off stack members during the update process as it may cause a switch to fail
on a subsequent boot.
Example
The following example updates the bootcode on unit 2.
console#update bootcode 2