Users Guide
Security Commands 1140
Denial of Service Commands
Dell EMC Networking N1100-ON/N1500/N2000/N2100-ON/N2200-
ON/N3000-ON/N3100-ON/N3200-ON Series Switches
The Dell EMC Networking DoS capability supports a package of filters
intended to provide network administrators the ability to reduce network
exposure to common attack vectors. The following list shows the DoS attack
detection Dell EMC Networking supports.
• SIP=DIP:
– Source IP address = Destination IP address.
• First Fragment:
– TCP Header size smaller then configured value.
• TCP Fragment:
– IP Fragment Offset = 1.
• TCP Flag:
– TCP Flag SYN set and Source Port < 1024 or TCP Control Flags = 0
and
– TCP Sequence Number = 0 or TCP Flags FIN, URG, and PSH set
and
– TCP Sequence Number = 0 or TCP Flags SYN and FIN set.
• L4 Port:
– Source TCP/UDP Port = Destination TCP/UDP Port.
• ICMP:
– Limiting the size of ICMP Ping packets.
• SMAC=DMAC:
– Source MAC address = Destination MAC address.
• TCP Port:
– Source TCP Port = Destination TCP Port.
• UDP Port:
– Source UDP Port = Destination UDP Port.
• TCP Flag & Sequence: