Users Guide

Layer 3 Routing Commands 1315
User Guidelines
MD5 must either be enabled or disabled on both peers. The same password
must be configured on both peers. After a TCP connection is established, if
the password on one end is changed, then the password on the other end
must be changed to match before the hold time expires. Using the default
hold times, both passwords must be changed within 120 seconds to guarantee
the connection is not dropped. The VLAN interface must also be specified if
a link-local address is specified.
Command History
Introduced in version 6.2.0.1 firmware.
Updated in version 6.3.0.1 firmware.
Example
console(config-router)#neighbor FE80::0202:B3FF:FE1E:8329 interface vlan 10
password sample
neighbor prefix-list (BGP Router Configuration)
Use the neighbor prefix-list command to filter advertisements sent to a
specific neighbor based on the destination prefix of each route.
Syntax
neighbor { ip-address | ipv6-address [interface vlan vlan-id]} prefix-list
prefix-list-name { in | out }
no neighbor { ip-address | ipv6-address [interface vlan vlan-id]} prefix-list
prefix-list-name { in | out }
• ip-address—The neighbor’s IPv4 address.
• prefix-list-name—The name of an IP prefix list.
• ipv6-address—The neighbor’s IPv6 address. If the neighbor’s IPv6 address
is a link local address, the local interface must also be specified. This
command is available in IPv6 address family mode.
• interface vlan vlan-id—The local interface/VLAN ID over which the IPv6
neighbor can be reached. Range: 1-4093.
• in—Apply the prefix list to advertisements received from this neighbor.