Users Guide

Layer 3 Routing Commands 1534
console#show ip route static
Route Codes: R - RIP Derived, O - OSPF Derived, C - Connected, S - Static
B - BGP Derived, E - Externally Derived, IA - OSPF Inter Area
E1 - OSPF External Type 1, E2 - OSPF External Type 2
N1 - OSPF NSSA External Type 1, N2 - OSPF NSSA External Type 2
S U - Unnumbered Peer, L - Leaked Route
No default gateway is configured.
S 10.0.0.0/8 [1/0] via Vl10
S U 6.1.0.6/32 [0/0] via Vl20
S U 6.2.0.6/32 [0/0] via Vl20
The following example shows a tracked route.
console#show ip route track-table
ipv6 route 0.0.0.0 0.0.0.0 10.130.167.129 track 10 state is [up]
show ip route preferences
Use the show ip route preferences command to display the default route
preference value for each origin.
Syntax
show ip route preferences
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
Route preferences are used in determining the best route. Lower router
preference values are preferred over higher router preference values. This
command displays the route preferences for each possible route origin.
Example
The following example displays IP route preferences.
console#show ip route preferences