Users Guide

Layer 3 Routing Commands 1557
Syntax
ipv6 nd managed-config-flag
no ipv6 nd managed-config-flag
Default Configuration
False is the default configuration.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
User Guidelines
This command has no user guidelines.
Example
In the following example, the end node uses DHCPv6.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 nd managed-config-flag
ipv6 nd ns-interval
Use the ipv6 nd ns-interval command in Interface Configuration mode to set
the interval between router advertisements for advertised neighbor
solicitations. An advertised value of 0 means the interval is unspecified.
Syntax
ipv6 nd ns-interval milliseconds
no ipv6 nd ns-interval
• milliseconds — Interval duration. (Range: 0, 1000–4294967295)
Default Configuration
0 is the default value for milliseconds.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode