Users Guide

Layer 3 Routing Commands 1636
no ipv6 pim
Default Configuration
PIM dense mode is disabled by default.
Command Mode
Global Configuration mode
User Guidelines
Only one of sparse or dense mode can be configured on a router. DVMRP
must be disabled before enabling PIM.
Example
console(config)#ipv6 pim dense
ipv6 pim dr-priority
Use the ipv6 pim dr-priority command to set the priority value for which a
router is elected as the designated router (DR). Use the no form of this
command to set the priority to the default.
Syntax
ipv6 pim dr-priority priority
no ipv6 pim dr-priority
• priority — The election priority (Range: 0–2147483647).
Default Configuration
The default election priority is 1.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
There are no user guidelines for this command.