Users Guide

Layer 3 Routing Commands 1640
Syntax
ipv6 pim rp-candidate vlan vlan-id group-address/prefixlength [interval
c_rp_interval ]
no ipv6 pim rp-candidate vlan vlan-id
• vlan-id — A valid VLAN ID value.
• group-address — The group address to display.
• prefixlength — This parameter specifies the prefix length of the IP address
for the media gateway. (Range: 1–128)
• c_rp_interval—The Candidate RP advertisement interval (range 1-16383
seconds, default 60 seconds).
Default Configuration
The router does not advertise itself as a PIM candidate rendezvous point by
default.
Command Mode
Global Configuration mode
User Guidelines
The default interval for a Candidate Rendezvous Point (C-RP) to send C-RP
Advertisement messages to the Bootstrap Router (BSR) is 60 seconds.
Example
console(config)#ipv6 pim rp-candidate vlan 6 ff1e::/64
ipv6 pim sparse-mode
Use the ipv6 pim sparse-mode command to administratively configure PIM
sparse mode for multicast routing. This command also enables MLD. Use the
no form of this command to disable PIM and MLD.
Syntax
ipv6 pim sparse-mode
no ipv6 pim