Users Guide

Layer 3 Routing Commands 1656
ip sla schedule
Use the ip sla schedule command to start an IP SLA. Use the no form of the
command to stop an IP SLA operation.
Syntax
ip sla schedule operation-number
no ip sla schedule operation-number
• operation-number—The number used to identify an IP SLA operation.
The range is 1 to 128.
Default Configuration
By default, there are no operations configured.
Command Mode
Global Configuration mode
User Guidelines
After configuring an IP SLA operation, the IP SLA is in pending state and
needs to be started using the ip sla schedule global configuration command.
To stop the operation and place it in the default state (pending), use the no
form of this command.
By default IP SLAs are not scheduled. Once an IP SLA is created using the ip
sla global configuration command it needs to be started (with a lifetime of
forever) by using the ip sla schedule CLI configuration command. When an
ip sla schedule command is issued the ip sla operation transitions from
pending state to active and immediately begins probing and collecting
information. The IP SLA probes can be stopped by using the no ip sla
schedule command.
To display the current operational state of an IP SLA operation, use the show
ip sla configuration command.