Users Guide

Switch Management Commands 1908
Command Mode
Global Configuration mode
User Guidelines
The configuration on the master switch controls the stack as if it is a single
switch. No configuration steps need to be taken on the member switches to
enable rebooting the member switches after auto-install downloads a new
firmware version.
Example
console#
console#configure
console(config)#boot host auto-reboot
console(config)#no boot host auto-reboot
boot host auto-save
Use the boot host auto-save command in Global Configuration mode to
enable automatically saving the downloaded configuration on the switch. Use
the no form of this command to disable automatically saving the downloaded
configuration on the switch.
Syntax
boot host auto-save
no boot host auto-save
Default Configuration
The default value is disabled.
Command Mode
Global Configuration mode