Users Guide

Switch Management Commands 2124
Default Configuration
Debug tracing is not enabled by default. By default, debug capability for the
the global VRF is configured.
Command Mode
Global Configuration mode
User Guidelines
Debug messages are sent to the system log at the DEBUG severity level. To
print them on the console, enable console logging at the DEBUG level
(logging console debug).
The debug options enabled for a specific peer are the union of the options
enabled globally and the options enabled specifically for the peer.
Enabling one of the packet type options enables packet tracing in both the
inbound and outbound directions.
Debug commands should be used with caution. Switch behavior may be
adversely affected by the additional processing load incurred by enabling
debug output.
If the vrf-name is specified, information pertaining to that VRF is displayed.
Command History
Introduced in version 6.2.0.1 firmware.
Updated in version 6.3.0.1 firmware.
Example
console#debug ip bgp 10.27.21.142 events
debug ip device tracking
Use the debug ip device tracking command to enable tracing of the IPDT
component. Use the no form of the command to disable IPDT tracing.
Syntax
debug ip device tracking