Users Guide

Switch Management Commands 2255
To disconnect a remote session to a stack member established from the stack
manager.
Stack-Master#connect 2
Remote session started. Type “exit” to exit the session.
(Unit 2 - CLI unavailable - please connect to master on Unit 1)>exit
Stack-Master#
Example 2:
To disconnect a remote session to the stack master established from a stack
member.
(Unit 2 - CLI unavailable - please connect to master on Unit 1)>connect 2
(Unit 2 - CLI unavailable - please connect to master on Unit 1)>
(Unit 2 - CLI unavailable - please connect to master on Unit 1)>connect 1
Stack-Master#
Stack-Master#exit
Stack-Master>exit
(Unit 2 - CLI unavailable - please connect to master on Unit 1)>
hardware profile portmode
Use the hardware profile portmode command to configure a 40G QSFP port
to operate in either 4x10G mode or 1x40G mode or to configure a 100G
QSFP port to operate in either 1x100G, 2x50G, or 4x25G mode.
Use the no form of the command to return the port to the default mode.
This command can only be executed on interfaces that support the
expandable ports feature. Entering the command on any other type of
interface will give an error.
NOTE: This command does not operate in interface range mode.
NOTE: This command is only valid on the N2200-ON and N3200-ON switches. It
issues an error response is used on any other switch model.