Users Guide

Switch Management Commands 2340
ip telnet server disable
The ip telnet server disable command is used to enable/disable the Telnet
service on the switch.
Syntax
ip telnet server disable
no ip telnet server disable
Command Mode
Global Configuration
User Guidelines
No specific guidelines.
Default Value
This feature is enabled by default.
Dell EMC Networking N-Series switches support the Telnet service over IPv4
and IPv6.
Example
console#configure
console(config)#ip telnet server disable
console(config)# no ip telnet server disable
ip telnet port
The ip telnet port command is used to configure the Telnet TCP port
number on which the switch listens for Telnet connections.
Syntax
ip telnet port port number
• port number — Telnet TCP port number (Range: 1025–65535)
Default Configuration
The default value for the Telnet TCP port is 23.