Users Guide

Switch Management Commands 2382
Example
The following example displays an HTTPS server configuration with DH Key
exchange enabled.
console#show ip http server secure status
HTTPS server enabled. Port: 443
DH Key exchange enabled.
Certificate 1 is active
Issued by: www.verisign.com
Valid from: 8/9/2003 to 8/9/2004
Subject: CN= router.gm.com, 0= General Motors, C= US
Finger print: DC789788 DC88A988 127897BC BB789788
Subject: /CN=DELL/OU=Dell Networking/L=Round Rock/ST=TX/C=US/emailAddress=
[e-mail]
Finger print: 1873B936 88DC3411 BC8932EF 782134BA
The following example displays the HTTPS server configuration with DH Key
exchange disabled.
console(config)#show ip http server secure status
HTTPS Server is Disabled. Port : 443
DH Key exchange disabled. Parameters are being generated.
Certificate 1 is active.
Issued by: Dell Networking
Valid from to Oct 22 17:46:02 2017 GMT
Subject: /CN=DELL/OU=Dell Networking/L=Round Rock/ST=TX/C=US/emailAddress=
[e-mail]
Fingerprint: FA06E0DD138FA22A4D696A80171FF3D8
state
Use the state command in Crypto Certificate Generation or Crypto
Certificate Request mode to specify the state or province name.
Syntax
state state
• state — Specifies the state or province name. (Range: 1–64 characters)
Default Configuration
This command has no default configuration.