Users Guide

Layer 2 Switching Commands 379
Syntax
show ipv6 verify [interface if-id]
• if-id—A valid interface ID (Ethernet)
Default Configuration
There is no default configuration for this command.
Command Modes
User Exec, Privileged Exec (all show modes)
User Guidelines
The filter type is one of the following values:
• ipv6-mac: User has configure MAC address filtering on this interface
• ipv6: IPv6 address filtering is configured on this interface
• N/A: No filtering is configured on the interface
Example
console(config-if-Gi1/0/5)#show ipv6 verify
Interface Filter Type
----------- -----------
Gi1/0/1 ipv6
Gi1/0/2 ipv6-mac
Gi1/0/3 N/A
Gi1/0/4 N/A
Gi1/0/5 ipv6-mac
Gi1/0/6 N/A
Gi1/0/7 N/A
Gi1/0/8 N/A
Gi1/0/9 N/A
console(config-if-Gi1/0/5)#show ipv6 verify interface gi1/0/5
Interface Filter Type
----------- -----------
Gi1/0/5 ipv6-mac