Users Guide

Layer 2 Switching Commands 422
The following table displays the interface mode codes and VLAN output
format for the interface mode:
Example
The following example displays the status for all configured interfaces.
console(config-if-Po1)#show interfaces status
Field Description
Port The port or port channel number. Oob means Out-of-Band
Management Interface.
Description Description of the port. This field may be truncated in the command
output.
Duplex Displays the port Duplex status.
VLAN The VLAN membership for the port is enclosed in parentheses. The
currently active PVID and Voice VLAN ID, if any, are also shown. In
some cases, the PVID assigned may not be the configured PVID, for
example, when RADIUS assigns a PVID to the interface.
Speed Refers to the port speed.
Neg Describes the Auto-negotiation status.
Link State Displays the Link status, either Up, Down, or
Disable. Disable is
displayed in the link status output for ports that are
administratively or error disabled.
Flow Ctrl
Status
Displays the Flow Control status, either Active or Inactive.
Mode VLAN
A – Access Native
T – Trunk (Native),List
D – Dot1q tunnel Outer
P – Private VLAN
Promiscuous
(Primary), Secondary List
H–Private VLAN Host (Primary), Secondary
G– General (PVID), All the tagged and untagged VLANs.