Users Guide

Layer 2 Switching Commands 431
console#show storm-control
802.3x Flow Control Mode....................... Disable
console#show storm-control gigabitethernet 1/0/1
Bcast Bcast Mcast Mcast Ucast Ucast Flow
Intf Mode Level Mode Level Mode Level Ctrl
---------- -------- --------- -------- --------- -------- --------- --------
Gi1/0/1 Disable 5 Disable 5 Disable 5 Disabled
switch-top(config)#show storm-control all
Bcast Bcast Mcast Mcast Ucast Ucast Flow
Port Mode Level Mode Level Mode Level Ctrl
---------- -------- --------- -------- --------- -------- --------- --------
Gi1/0/1 Enable 90 Enable 5 Enable 10 Enabled
Gi1/0/2 Disable 5 Disable 5 Disable 5 Enabled
Gi1/0/3 Disable 5 Disable 5 Disable 5 Enabled
Gi1/0/4 Disable 5 Disable 5 Disable 5 Enabled
Gi1/0/5 Disable 5 Disable 5 Disable 5 Enabled
Gi1/0/6 Disable 5 Disable 5 Disable 5 Enabled
Gi1/0/7 Disable 5 Disable 5 Disable 5 Enabled
Gi1/0/8 Disable 5 Disable 5 Disable 5 Enabled
show storm-control action
Use the show storm-control action command to display the storm control
action configuration for one or all interfaces.
Syntax
show storm-control action {all | interface-id}
• all —Show the storm control action configuration for all interfaces.
• interface-id—An Ethernet interface on which storm control is enabled.
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode and all show modes