Users Guide

Layer 2 Switching Commands 445
ethernet cfm mep enable
Use the ethernet cfm mep enable command in Interface Configuration mode
to enable a MEP at the specified level and direction. Use the no form of the
command to disable the MEP.
Syntax
ethernet cfm mep enable level 0-7 vlan vlan-id mpid 1-8191
• level—Maintenance association level
• mpid— Maintenance entity identifier
• vlan— VLAN on which the MEP operates. The range is 1-4093.
Default Configuration
No MEPs are preconfigured.
Command Mode
Interface Configuration mode
User Guidelines
The maintenance domain must exist for it to be enabled.
Example
The following example enables a maintenance endpoint at level 1 with mpid
1010 on vlan 10.
console(config-if-Gi1/0/3)#ethernet cfm mep enable level 1 vlan 10 mpid 1010
ethernet cfm mep active
Use the ethernet cfm mep active command in Interface Configuration mode
to activate a MEP at the specified level and direction. Use the no form of the
command to deactivate the MEP.
Syntax
ethernet cfm mep active level 0-7 vlan vlan-id mpid 1-8191
• level—Maintenance association level