Users Guide

Layer 2 Switching Commands 660
User Guidelines
This command has no user guidelines.
mvr querytime
Use the mvr querytime command in Global Configuration mode to set the
MVR query response time. The query time is the maximum time to wait for
an IGMP membership report on a receiver port before removing the port from
the multicast group after receiving a leave message. The query time only
applies to receiver ports and is specified in tenths of a second.
Use the no form of the command to set the MVR query response time to the
default value.
Syntax
mvr querytime 1–100
no mvr querytime
Default Configuration
The default value is 5 tenths of a second.
Command Mode
Global Configuration
User Guidelines
The following table lists the completion messages.
Example
console(config)#interface Gi1/0/1
console(config-if-Gi1/0/1)#switchport access vlan 2
console(config-if-Gi1/0/1)#mvr
console(config-if-Gi1/0/1)#mvr type receiver
console(config-if-Gi1/0/1)#exit
Message Type Message Description
Successful Completion Message Defaulting MVR query response time.
Error Completion Message None