Users Guide

Layer 2 Switching Commands 661
console(config)#mvr mode dynamic
console(config)#mvr querytime 10
mvr vlan
Use the mvr vlan command in Global Configuration mode to set the MVR
multicast VLAN. Use the no form of the command to set the MVR multicast
VLAN to the default value.
Syntax
mvr vlan vlan-id
no mvr vlan
• vlan-id — Specifies the port on which multicast data is expected to be received.
Source ports should belong to this VLAN.
Default Configuration
The default value is 1.
Command Mode
Global Configuration
User Guidelines
The following table lists the completion messages.
mvr immediate
Use the mvr immediate command in Interface Configuration mode to enable
MVR Immediate Leave mode. Use the no form of this command to set the
MVR multicast VLAN to the default value.
Message Type Message Description
Successful Completion Message MVR multicast VLAN ID is set to the
default value which is equal to 1.
Error Completion Message Receiver port in mVLAN, operation failed.