Users Guide

Layer 2 Switching Commands 886
Default Configuration
Dell EMC Networking switches use dot1q encapsulation on trunk ports by
default.
Command Mode
Interface config mode, Interface range mode (including port-channels)
User Guidelines
This command performs no action. Dell EMC Networking switches always
use dot1q encapsulation on trunk mode ports.
Command History
Introduced in version 6.2.0.1 firmware.
Example
This example demonstrates compatibility.
console(config-if-Gi1/0/1)#switchport trunk encapsulation dot1q
vlan
Use the vlan command in Global Configuration mode to configure a VLAN.
To delete a VLAN, use the no form of this command.
Syntax
vlan {vlan–list}
no vlan {vlan–list}
• vlan–list—A list of one or more valid VLAN IDs. List separate, non-
consecutive VLAN IDs separated by commas (without spaces). Use a
hyphen to designate a range of IDs. (Range: 1–4093)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration (Config)