Users Guide

Switch Management Commands 2265
• bgp state-changes limited—Enable standard traps defined in RFC 4273.
• port-security—Enable traps on port security violations.
• port-security trap-rate—Configure the interval at which port security
traps are issued. Range 1-1000000 seconds. Default 30 seconds.
• buffers—Enables sending of a trap on the internal message buffer count
exceeding the rising threshold.
• cpu threshold—Enables sending of a trap on the CPU occupancy
exceeding the rising threshold.
• multiple-users—Enable sending a trap when multiple logins are active.
• link—Enable sending a trap when a link (interface) transitions to the
active state or the inactive state.
• violation—Enable sending a trap when a port security MAC locking
violation occurs.
•
vrf-name —The name of an existing VRF instance
• dvmrp—Enable DVMRP traps.
• port-security —Enable traps on port security violations.
• ospf—Enable OSPF event traps.
• ospfv3—Enable OSPFv3 event traps.
• pim—Enable PIM traps (pim-sm and pim-dm).
• poe —Enable PoE traps. This parameter is only available on PoE capable
switches.
• snmp authentication —Enable SNMP authentication traps.
• spanning-tree—Enable traps on topology changes.
• vrrp —Enable VRRP traps.
• mac-notification — Send MAC address addition and removal traps.
Default Configuration
SNMP authentication, link, multiple-user, spanning-tree, dot1q, and ACL
traps are enabled by default. Port-security traps are enabled by default.
Command Mode
Global Configuration mode.