Users Guide

Switch Management Commands 2338
logout
Use this command to disconnect the serial connection to the remote unit on
the stack member.
Syntax
logout
Default Configuration
There is no default configuration for this command.
Command Modes
User Exec mode on the management unit in the stack. Unit prompt on the
stack member.
User Guidelines
This command is available in User Exec mode on the primary unit serial port
and from the Unit prompt on member unit serial ports. The user need not be
currently connected over the serial port to connect to another unit.
The stack member being connected to must be up and running and
connected as part of the stack.
This command is an alias for the exit command.
Example
(Example 1:
To disconnect a remote session to management unit in the stack established
from a stack member.
Unit 2 - CLI unavailable - please connect to primary on Unit 1)>connect 1
Stack-Primary#
Stack-Primary#logout
(Unit 2 - CLI unavailable - please connect to primary on Unit 1)>
Example 2:
To disconnect a remote session to management unit in the stack established
from a stack member.
(Unit 2 - CLI unavailable - please connect to primary on Unit 1)>connect 1
Stack-Primary#exit