Users Guide

Switch Management Commands 2348
The reload command checks for stack port errors prior to reloading stack
members and after the check for unsaved configuration changes. If stack port
errors are found, a message is displayed.
Syntax
reload [ stack–member–number ]
•
stack–member–number —The stack member to be reloaded.
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode
User Guidelines
If no unit is specified, all units in a stack are reloaded. When copying
firmware onto the switch in a stacked configuration, use the show sfs and
show version commands to check the status of stack firmware
synchronization prior to a reboot.
Examples
Example-Reloading the Stack
The following example displays how to reload the stack.
console#reload 1
Management switch has unsaved changes.
Would you like to save them now? (y/n)n
Configuration Not Saved!
Are you sure you want to reload the switch? (y/n) y
Reloading management switch 1.
Example-Stack Port Errors
The following example shows stack port errors detected by the command.
console#reload
Management switch has unsaved changes.
Are you sure you want to continue? (y/n)