Users Guide

Switch Management Commands 2413
Syntax
update bootcode [ unit ]
•
unit —Unit number.
Default Configuration
By default, all units in the stack are updated.
Command Mode
Privileged Exec mode
User Guidelines
This command applies to the N1100/N1500/N2000/N2100-ON/N2200-
ON/N3000/N3100-ON/N3200-ON Series switches only.
It is not required to update the boot code unless directed to do so in the
release notes. Dell EMC Networking switches utilize a universal boot loader
and do not contain version specific dependencies in the boot loader. If
unit is
not specified, all units in the stack are updated.
This command does not reboot the stack members after the update
completes. Do not reload or power off stack members during the update
process as it may cause a switch to fail on a subsequent boot.
It is recommended that the stack be rebooted after a bootcode update to
ensure that all stack members are properly updated.
Example
The following example updates the bootcode on stack unit 2.
console#update bootcode 2