Users Guide

Layer 2 Switching Commands 598
Command Mode
Global Configuration mode
User Guidelines
When enabled, if there is another querier in the network and the local querier
is in election mode, then the querier with the lower IP address is elected and
the other querier stops querying. If the local querier is not in election mode
and another querier is detected, the local querier stops querying.
Example
console(config-vlan)#ipv6 mld snooping querier election participate 10
ipv6 mld snooping querier query-interval
Use the ipv6 mld snooping querier query-interval command to set the MLD
Querier Query Interval time. Use the no form of this command to reset the
Query Interval to the default.
Syntax
ipv6 mld snooping querier query-interval interval
ipv6 mld snooping querier query-interval
•
interval — Amount of time that the switch waits before sending another
general query. (Range: 1–1800 seconds)
Default Configuration
The default query interval is 60 seconds.
Command Mode
Global Configuration mode
User Guidelines
The query interval is the amount of time in seconds that the switch waits
before sending another general query.
Example
console(config)#ipv6 mld snooping querier 120