Users Guide

Layer 2 Switching Commands 784
Interface...................................... Te1/0/23
Mac Address.................................... 00:1B:21:96:10:2E
User Name...................................... testUser
VLAN Assigned Reason........................... RADIUS Assigned VLAN (100)
Host Mode...................................... multi-domain-multi-host
Method......................................... 802.1X
Control Mode................................... auto
Session time................................... 95
Session timeout ............................... 0
Session Termination Action..................... Default
Filter ID......................................
RADIUS Framed IPv4/IPv6 address................
DACL...........................................
Redirect ACL...................................
Redirect URL...................................
Acct SessionId................................. testUser:1700000003
Linksec policy................................. must-secure
Command History
Command syntax, and command output, updated in version 6.7.0 firmware.
policy-map
Use the policy-map command in Global Configuration mode to establish a
new DiffServ policy or to enter policy map configuration mode. To remove
the policy, use the no form of this command.
NOTE: This command is not available on the N1500 Series switches.
Syntax
policy-map policyname [in|out]
no policy-map
policyname
• policyname — Specifies the DiffServ policy name as a unique case-
sensitive alphanumeric string of characters. (Range: 1–31 alphanumeric
characters.)
• in—The policy is applied on ingress. Must be specified to create new
DiffServ policies. An existing policy can be selected without specifying
“in” or “out”.