Users Guide

Security Commands 980
Each method can only be entered once. There are no restrictions on the
ordering of priorities.
For a laptop or desktop and phone combination where both devices
authenticate using IEEE 802.1X, it is recommended to configure both the
authentication priority and order as dot1x.
Example
console(config-if-Gi1/0/1)# authentication priority mab dot1x captive-portal
console(config-if-Gi1/0/1)# no authentication priority
authentication timer restart
Use this command to set the interval after which reauthentication starts. This
timer starts only if all the authentication methods fail.
Use the no form of this command to set the authentication restart timer to
factory default value.
Syntax
authentication timer restart time
no authentication timer restart
•
time —The time, in seconds, after which reauthentication starts, if all the
authentication methods have failed. Range: 300-65535.
Default Configuration
The default timer value is 300 seconds.
Command Modes
Interface Configuration (Ethernet) mode
User Guidelines
None
Command History
Syntax updated in version 6.6 firmware.