Administrator Guide

1046 Link Aggregation
Figure 28-5. LAG Membership
Adding a Port to a Static LAG
To add a static LAG member:
1 Open the LAG Membership page.
2 Click in the LAG row on the desired port and enter the number of the
LAG to which the port should be added. For example, the following figure
shows ports Gi1-Gi4 being added to LAG 1, and ports Gi5-Gi8 being
added to LAG 2.
3 Click Apply.
The port is assigned to the selected LAG, and the device is updated.
Adding a LAG Port to a Dynamic LAG by Using LACP
To add a dynamic LAG member:
1 Open the LAG Membership page.
2 Click in the LACP row to toggle the desired LAG port to L.
3 Click Apply.
The LAG port is added as a dynamic LAG member to the selected LAG.
NOTE: The port must be assigned to a LAG before it can be aggregated
using LACP.