CLI Guide

Security Commands 1006
Command Mode
RADIUS Server Accounting mode
User Guidelines
There are no user guidelines for this command.
Example
The following example sets port number 56 for accounting requests.
console(config)#radius server acct 3.2.3.2
console(Config-acct-radius)#acct-port 56
attribute 6
Use the attribute 6 command to configure processing of the RADIUS
Service-Type attribute.
Syntax
attribute 6 [on-for-login-auth|mandatory]
no attribute 6 [on-for-login-auth|mandatory]
Default Configuration
By default, the Service-Type is not included in the Access-Request message
sent to the authentication server.
Command Mode
RADIUS Server Configuration
User Guidelines
on-for-login —If the on-for-login parameter is enabled, the Service-Type TLV is
send in the Access-Request message.
mandatory—If the mandatory parameter is enabled, the Service-Type
attribute is required and validated in the Access-Accept packet received from
the RADIUS server. Dell EMC Networking N-Series switches accept the
Login-User (1) and Administrative-User (6) values in the Access-Accept