CLI Guide

Table Of Contents
Security Commands 1118
http port
Use the http port command to configure an additional HTTP port for captive
portal to listen for connections. Use the “no” form of this command to
remove the additional HTTP port from monitoring.
Syntax
http port port-num
no http port
port-num The port number on which the HTTP server listens for
connections
(
Range: 1025–65535).
Default Configuration
Captive portal only monitors port 80 by default.
Command Mode
Captive Portal Configuration mode
User Guidelines
The port number should not be set to a value that might conflict with other well-
known protocol port numbers used on this switch.
Example
console(config-cp)#http port 32768
console(config-cp)#no http port
https port
Use the https port command to configure an additional HTTPS port for
captive portal to monitor. Use the “no” form of this command to remove the
additional HTTPS port.
Syntax
https port port-num
no https port