CLI Guide

Dell EMC Networking CLI 183
Loopback Interface
Multicast
Command Description Mode
a
a. For the meaning of each Mode abbreviation, see Mode Types .
interface loopback Enters the Interface Loopback configuration
mode.
GC
show interfaces loopback Displays information about configured
loopback interfaces.
PE
Command Description Mode
a
arp Adds an administrative scope multicast
boundary.
IC
ip mroute Creates a static multicast route for a source
range.
GC
ip multicast-routing Sets the administrative mode of the IP
multicast forwarder in the router to active.
GC
ip multicast ttl-threshold Applies a ttlvalue to a routing interface. IC
ip pim Administratively configures PIM mode for IP
multicast routing on a VLAN interface.
IC
ip pim bsr-border Administratively disables bootstrap router
(BSR) messages from being sent or received
through an interface.
IC
ip pim bsr-candidate Configures the router to advertise itself as a
bootstrap router (BSR).
GC
ip pim dense-mode Administratively configures PIM dense mode
for IP multicast routing.
GC
ip pim dr-priority Administratively configures the advertised
designated router (DR) priority value.
IC
ip pim hello-interval Administratively configures the PIM Hello
messages on the specified interface.
IC
ip pim join-prune-interval Administratively configures the frequency of
join/prune messages on the specified interface.
IC